1 請計算 A、B 兩處的作用力,當α角為 30∘時? (A) A=165N; B=165N (B) A=430N; B=275N (C) A=219N; B=141.5N(D)A=275N; B=4
1、 請計算 A、B 兩處的作用力,當α角為 30∘時? (A) A=165N; B=165N (B) A=430N; B=275N (C) A=219N; B=141.5N(D) A=275N; B
2、 What mechanism can cause the entropy of a control mass to decrease?(A) Work done on the system (B
3、 Using the parallel-axis theorem, determine the product of inertia of the area shown withrespect t
5、 Which of the following failure theories is the most conservative?(A) Maximum normal stress theory
9、 The coefficient of static friction between the cord and the fixed shaft as shown is 0.2. What ist
12、 A bar made of A-36 steel has the dimensions shown in Figure 12. An axial force P= 80kN isapplied
13、 水平桌面上有一油膜 (其黏性係數為 0.40 N-s/m2),油膜上有一平板以 5 m/s 之速度水平移動。若油膜內之剪應力為 1 kPa,則油膜厚度為何?(A) 0.2 mm (B) 1.6
15、 以彈簧秤測一物重。若該物完全沒入水中時彈簧秤讀數為 275 N,且當該物完全沒入比重為 0.9 之油中時彈簧秤讀數為 325 N,則該物體積最接近下列何者?(A) 0.02 m3(B) 0.0
18、 一水管之內直徑為 0.3 m,且其末端以一出口直徑為 0.15 m 之噴嘴相連接。若管內流體 (水) 之體積流率為 0.25 m3/s,則使該水管固定不動所需之力最接近下列何者?(A) 660
19、 若利用一 1:12 尺寸之模型實驗來研究某一洩洪道之流場特性,且該洩洪道之設計排水流率為 180 m3/s,則模型實驗中之排水流率應為下列何者?(A) 0.36 m3/s (B) 1.25 m
20、 水流以 45L/min 的穩定速率從水龍頭流入矩形空間(0.5m*1.5m*0.6m)的泳池中,試估算泳池中水位高度的變化率 (cm/min): (A) 5cm/min (B) 2.5cm/m
22、 In Figure 22, the gate is 3 m wide and weightless. To keep this rectangular gate to be inequilib
29、 銅在鋁中 500ºC 和 600ºC 的擴散係數分別是 4.8x10-14m2/s 和 5.3x10-13 m2/s,試決定在500ºC 時,需時多久才會有與 600ºC 擴散 10 小時(h