資訊推薦

• 6. 油輪在裝卸貨時調整壓艙水與下列何項無關？ (A)保持正常的船體壓力 (B)保持適當的吃水與俯仰差 (C)保持船舶穩定度 (D)維持壓水艙在惰化狀態
• 7. IGC Code之整體艙(Integral Tank)可承受之壓力通常不超過多少Bar？ (A)0.2Bar(B)0.25Bar (C)0.3Bar (D)0.5Bar
• 8. 液化天然氣船（LNG Carrier)之貨溫通常保持在攝氏多少度？ (A)-162℃ (B)-102℃(C)-90℃ (D)-48℃
• 9. 船舶 T.P.I 值是： (A)常數 (B)隨 M.T.I 而改變 (C)隨吃水而改變 (D)隨水深而改變
• 10. 液體黏度越高，則其流動性為何？ (A)越大 (B)越小 (C)相同 (D)兩者不相關
• 11. 船舶發生橫搖，傾斜前後兩條浮力作用線的交點稱為： (A)浮面中心 (B)縱穩心 (C)浮心 (D)橫穩心
• X The Knuth-Morris-Pratt (KMP) algorithm is an string-matching algorithm. Its core is the pre-fix fu
• 12. 下圖所示，該船型式應屬下列何種？ (A)貨櫃船 (B)散裝船 (C)天然氣瓦斯運送船 (D)油輪
• 15. 線性方程組經高斯消去法計算後，其增廣矩陣可化簡為，則【題組】 (1)a = ______
• 8. If = 2y, with y(0) = -1, what is y(0.5)?(AB) 0.368 (AC) 2.718 (AD) 5.436 (AE) 0.736 (BC) 8. 1 55
• XI Many string-matching algorithms build a finite automata. Below is a partially-completed statetran
• (b) Now consider an chessboard for some fixed . For , how manyke squares are contained in this ches
• 【題組】1.2 Based on your design, if you could halve the cycle latency of any single category of instruc
• 【題組】1.3 What is the CPI of your new design?
• 【題組】1.4 What is the speedup of your revised design over the original one, rounded to the nearest ten
• 2. The standard pipeline has five stages: fetch(F), decode (D), execute (X), memory (M), andwritebac
• 【題組】2.2 What specific positive impact would combining the "X" and "M" stages hav
• 【題組】2.3 What specific positive might combining the "M" and "W" stages have on th
• 【題組】2.4What specific impact would combining the "F" and "D' stages have on the i
• 【題組】2.5 If a single-cycle datapath with delay of n nanoseconds is converted into a pipelined datapat
• 3. Please answer the following questions:【題組】3.1 What do VLIW, superscalar execution, and array proc
• 【題組】3.2 Provide two reasons why a VLIW microarchitecture is simpler than a "same-width" su
• 【題組】3.3 Provide two reasons why a superscalar microarchitecture could provide higher performance tha
• 13. 某一油品其比重(S.G60℉/60℉)為0.8762，請問換算為API為多少？ (A)API 10 (B)API20 (C)API 30 (D)API 40
• 14. 下列何者不是雜貨船配載時考慮的重點？ (A)航程的遠近 (B)海水密度之測定 (C)季節期帶區域 (D)裝卸工人之多寡