資訊推薦

• 【題組】35. (A) proceed (B) pursue (C) peculate (D) persist
• Given that bureaucracy is held in such ill repute today, it is hard to remember that it was oncecons
• 【題組】37. (A) end (B) finish (C) culmination (D) termination
• 【題組】38. (A) carried (B) spread (C) caught (D) pulverized
• 【題組】39. (A) opened (B) sprang (C) fired (D) launched
• 【題組】40. (A) lured (B) held (C) knew (D) fell
• 2022 was the year of “goblin mode.” In 2022, the guardrails came off. People went raw,unfiltered and
• 【題組】42. According to the passage, which statement is NOT true?(A) The Oxford word of the year 2022 i
• 【題組】43. According to the passage, which statement is NOT true about “goblin mode” ?(A) The term depi
• 【題組】44. Which statement is true about the viral tweet that spiked the interest in “goblin mode” ?(A)
• 【題組】45. Which word is also a Word of the Year selected by dictionaries?(A) cottage-core (B) metavers
• The news that one of the Hollywood superstars was diagnosed the aphasia drew everyone’sattention on
• 【題組】47. What was one of the impacts of the combination therapy with SAT and SLT?(A) Reduced direct a
• 【題組】48. What information was true in Liu et al.’s design of research?(A) Different instruments were
• 【題組】49. What is needed to improve awareness of the benefits and cost-effectiveness of SAT?(A) Increa
• 【題組】50. What did the economic analysis demonstrate about scalp acupuncture therapy (SAT) incompariso
• 1. 一人重800N，站在一重200N之平台上，左右手各垂直下拉繩索，如圖(一)所示。重力加速度為10m/s2，滑輪及繩索之摩擦力與質量均忽略不計。欲使此人站在平台上且平台維持不動，則此人左、右手施力
• 48.企業經營電子商務若選擇不自行開發平台，而與網路開店平台廠商合作，由網路開店平台廠商處理網站的維護與管理等工作。下列何者不是平台廠商？(A)SHOPLINE(B)IKEA(C)Cyberbiz(D
• ▲閱讀下文，回答第49-50題快樂國小3年1班導師針對全班20位學生的考試結果處理程序如下：①利用Excel試算表將個別學生二科以上(含二科)不及格者顯示V，以便後續加強輔導②導師利用Word合併列印
• 2. 若無維修空間考量，下列手工具操作的優先順序何者正確？(甲)活動扳手、(乙)開口板手、(丙)套筒扳手、(丁)梅花板手(A) 丙→丁→甲→乙(B) 乙→丁→丙→甲(C) 丙→丁→乙→甲(D) 甲→乙
• 3. 有關引擎機油更換的敘述，下列何者錯誤？(A) 發動引擎達到正常工作溫度後，將引擎熄火，再洩漏機油(B) 安裝新的機油濾清器時，先在密封橡皮圈上塗抹少量機油(C) 先用手將機油濾清器鎖入至密封圈碰
• 4. OBDII 診斷接頭（DLC）的腳位有幾位？(A) 6(B) 8(C) 12(D) 16
• 5. 關於二氧化鋯型含氧感知器之敘述，下列何者正確？(A) 感知器內部為中空可導入大氣，外部則與排氣管的廢氣接觸(B) 感知器輸出電壓為 0.9V 時，表示混合汽的空氣過剩率 λ 值大於 1(C) 感
• 6. 曲軸軸承片裝入軸承座後，應注意什麼？(A) 凸出軸承座平面處應銼平(B) 兩端應與軸承座平齊(C) 軸承片兩端應比座之平面稍微凸出(D) 軸承片在座中應能自由活動
• 7. 下列對於點火系統的檢修何者錯誤？(A) 量測火星塞間隙使用厚薄規(B) 火星塞中央電極之溫度應保持在 450-850℃間(C) 火星塞拆裝須使用具有磁性或橡皮套圈之火星塞套筒拆裝(D) 燃燒室溫